first time reinstalling engine
-
- Posts: 23
- Joined: April 30th, 2008, 8:29 pm
first time reinstalling engine
I just got my engine back after having it rebuilt and in my shop manual it says to "Apply a light coating of moly-based grease to the splines of the transaxle imput shaft and the faace of the clutch release bearing." My question is. Is there a specific type of grease I need to use or will any moly-based grease work?
Re: first time reinstalling engine
To be honest I have never ( in 45 years) applied any grease on the throw out bearing face. I do however use an input shaft when I install the clutch disc to center it and a dab of grease always goes on the end to grease the needle bearing inside the gland nut- which could/would be accomplished by putting the grease on the input shaft. We are talking a small amount here as you do not want it thrown around.
As to type of grease- never gave it much thought.
Dietmar
http://www.quixoteracing.com
As to type of grease- never gave it much thought.
Dietmar
http://www.quixoteracing.com
-
- Posts: 23
- Joined: April 30th, 2008, 8:29 pm
Re: first time reinstalling engine
The clutch was reinstalled when the engine was rebuilt so that part is done. Thanks for the advice Dietmar.
Re: first time reinstalling engine
You are welcome.
And just for clarification, I put grease on the NON splined part of the input shaft so that it greases the gland nut bearing, NOT the splines of the input shaft.
Dietmar
http://www.quixoteracing.com
And just for clarification, I put grease on the NON splined part of the input shaft so that it greases the gland nut bearing, NOT the splines of the input shaft.
Dietmar
http://www.quixoteracing.com